MITSUBOSHI BELT PENCIL-1 Thiết bị căn chỉnh lực căng dây 150N/ 15kgf

MITSUBOSHI Japan

Pencil type belt tension gauge

Model: Pencil-1

V-Belt Tension Gauge  Proper tension is the key to long, efficient, trouble-free belt operation. When you install a new set of belts, use the gauge to establish correct tension. Then, to maintain performance, re-check belt tension after 24-48 hours. The payoff is maximum belt life, reduced downtime and uninterrupted equipment service. Belt Tension testers are for checking tensions on your synchronous belt drives and V-Belt. How To Check V-Belt Tension Proper drive belt tension is a critical setting on your factory. A loose drive belt can cause problems like wavy cuts or diving blades. An overtightened drive belt can cause premature wear and failure on many parts of the sawmill including cylindrical drive bearing, drive belt, and even engine failure. The drive belt used on your factory is a V belt design. The V belt transfers power from the drive pulley to the driven pulley. A properly tensioned belt will sit in the V groove of the pulley so that the sides of the belt are the only surfaces touching. This position allows the belt to grip the pulley and still have some slippage if the drive gets in a bind. The only way to properly set the drive belt tension is to use a belt tension gauge (MITSUBOSHI V-Belt tension gauge pencil type ). Belt tension is set by the amount of pounds (force) it takes to move the tightened belt a set amount of inches. To find this setting for your sawmill, refer to the Drive Belt Tension Measurement Guide on this page or review in your sawmill manual. Manual Belt Tension Tester The spring scale type tester measures how much force is required to deflect the belt a specified distance at the center of its span. This is the force deflection method of tensioning belts. The Sonic Tension Meter measures the vibration of the belt span and instantly converts the vibration frequency into belt static tension. This is the span vibration method of tensioning belts. [embedyt] https://www.youtube.com/watch?v=JRGkh5sUQXE[/embedyt] Video: How To Measure Belt Deflection | Pencil type belt tension gauge Specification The Mitsuboshi V-Belt Check Pencil-1 is a simple, spring-loaded tension gauge used for measuring the tension (deflection force) of V-belts, with a load range of 15 kg (approx. 150 N or 35 lbs) and a measurement range of 60 mm.

• Load Range: 15 kg (approximately 150 N or 35 lbs)
• Measurement Range: 60 mm
• Overall Length: 200 mm
• Material: Steel plate
• Gross Weight: Approximately 62 g to 65 g
• Capabilities: Designed for use with general industrial V-belts, including standard V-belts and Red Label V-belts. It is suitable for specific cross sections such as 3V, 3VX, 5V, and 5VX, among others.

Pic.: MITSUBOSHI V-Belt tension gauge ( 15Kgf/150N) at Semiki's warehouse

• It operates as a spring-loaded measuring tool to check the force required to deflect a V-belt by a specific amount (up to its 60mm range).
• This measurement ensures the belt is within the proper tension specifications provided by the manufacturer for optimal performance and longevity.
• The manufacturer recommends re-tensioning a new V-belt within 24 hours after initial tensioning to account for initial elongation.

Maintenance and calibration :  ► We also have calibration certificate attached ( optional ) ► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI Ins DISTRIBUTED BY: Semiki instrumentation Co., Ltd Email:  sales@semiki.com Office tel: +84 28 2253 3522 ~DOING OUR BEST FOR YOU~