Up to 10 models can be registered to set test conditions.

Easy to call standard values, which simplifies testing

Simple and precise inspection could be cobducted in two test modes

It is equipped with a mode for determining CW/CCW and measuring the magnetic flux distribution.

Auto-detect sensitivity adjustment by auto gain function

There is no adjustment required for each model, and it can be tested only by the initial setting.

Power suply		AC90V-240V 50/60Hz
Excitation Signal	Phase	Three Phase
	Frequency	5kHz　（Sine wave）
	Excitation voltage	Phase 5Vp-p
	Setting range	100 steps
Detection	Sensitivity Range	10 steps＋Auto setting range mode
	Corresponding poles	2/4極（Normal diecotor） 2/4/6/8極（Option ditector）
	Outer diameter of ditector	2/4 pole(Normal type）：Φ38mm 2/4 pole（Option type）：Φ22mm 2/4/6/8 pole（Option type）Φ45mm
General	Environment	Temperature range5℃-40℃　Humid range20%-80%
	Dimensions/Weights	H98×W195×D350 (mm)/1.8kg
	Power consumption	40VA以下
	Communication	I/O、RS232C
Accessories		Power cable (3m) 　　　　　　　　1 unit 3P-2P conversion adapter 　　　　1 unit Diteotor Cable（1.5m)　　　　　　1 unit Excitation signal cable (1.5m)　　 1 unit Normal Ditector Coil 　　　　　　　1 unit Manual　　　　　　　　　　　　　 1unit Spare Fuse（1A）　　　　　　　　 1unit

"Test mode 1" which simply detects CW/CCW and "Test mode 2" which graphs the causation voltage and detects abnormality for each phase can be set. p> In test mode 1, the detector senses the magnetic field generated when a voltage is applied to the stator. It detects the intensity and direction of rotation of the entire magnetic field. Since positioning is not required in test mode 1, It is possible to test in a simple way. In test mode 2, the positional relationship between the detector and the winding is fixed, and the test is performed in the same way as in test mode 1. In this mode, the eight coils built into the detector (if standard) allow you to see the distribution and runout width of each magnetic field on the screen, so you can detect even the smallest NG, such as winding or poor connectivity in one place.

■Specification and a design may be changed without a preliminary announcement for improvement reasons etc. ■There may be difference in a color, textures, etc. may be on the photograph which are written on the catalog during printing. ■Although an effort is made to indicate exact information about the contents of this catalog, if there should be a point of advice , such as a clerical error, please give a notice to sales promotion division of our company.

Maintenance and calibration :

► We also have calibration certificate attached ( optional ) ► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI CORP