Universal Punch #9040 dưỡng đo độ sâu lục giác hệ mét (9040-0.7 ~9040-24)

UNIVERSAL-PUNCH

Metric Hexagon Penetration Gages Model: #9040 Series

The Universal Punch #9040 Metric Hexagon Penetration Gages are precision inspection tools used to verify the internal hexagon depth in metric screws and fasteners against specific international standards. The exact dimensional specifications (tolerances, min/max depths) are dependent on the specific fastener size being gaged and the standard (e.g., ISO, ASME, DIN) it conforms to.

• Manufacturer: Universal Punch Corp.
• Purpose: To measure the minimum and maximum allowable penetration depth of a corresponding hex key or driver bit into a metric hexagon socket.
• Standards: These gages are made to conform with various international standards, including ASME/ANSI, ISO, DIN, JIS, BS, and GB specifications.
• Sizes: They are available in a range of metric sizes, typically from 0.7mm up to 24mm.
• Variations: The gages can be ordered as a basic probe or with an analog or digital dial indicator for precise depth readings.
• Material and Quality: The gage probes are heat-treated, thermally stabilized, and surface-treated for maximum wear resistance. All gages are calibrated and traceable to the National Institute of Standards and Technology (NIST).

Pic.: Universal-Punch Corp depth gages #9040 METRIC HEXAGON PENETRATION GAGES #9040-04 ( drive size 4 ) at Semiki’s warehouse

Specification

Gage Type: Penetration Gage (measures internal depth) Measurement Units: Metric (mm) Available Sizes: 0.7mm to 24mm (common sizes include 1.5mm, 2mm, 2.5mm, 3mm, 4mm, 5mm, 6mm, 8mm, 10mm, 12mm, etc.) Standards Conformance: Designed to conform to ASME/ANSI, ISO, JIS, DIN, BS, and GB gaging standards Material : Gage probes are heat-treated, thermally stabilized, and surface-treated for wear resistance. The base material is not explicitly listed for the gage itself, but related punches use ASP-30PM material with a hardness of RC 64-66. Finish/Coating: Standard finish; PVD coatings are available as an option upon request. Traceability: All gages are calibrated to specified dimensions and are traceable to the National Institute of Standards and Technology (NIST). Indicator : Available as a basic probe without an indicator