thước cặp điện tử Kanon digital Centerline calipers

 

Bestool-Kanon Venier Calipers

 

Model: E-RM-J, E-RZ, RM-DX Series

 

 

E-RM-J Series Measure for distance between center to center of holes :

By setting the upper side offset value (15.00 mm) and the lower offset value (7.50 mm),
 this instrument allows the measured center distance to be indicated as actual size. 
This saves time for addition or subtraction of indicated value that is required by former instruments, resulting easier use.

 

 

 

Picture : Kanon E-RM-15J ( 0~150mm ) Centerline caliper for distance between center to center of holes with equal diameter at Semiki's warehouse.

 

 

E-RX Series For measuring circular center distance of holes

The center distance of holes can be measured through direct reading. 
Holes with a diameter of 20 mm at the maximum can be measured.
The printer output function is provided.

 

 

 

E-RZ For measurement of distance "between edge face and hole"

The distance between edge face and hole can be measured through direct reading. 
Holes with a diameter of 20 mm at the maximum can be measured.
The printer output function is provided

 

E-RM60B: Adequate for center distance measurement for holes with equal diameter on long work

 

 

● Long vernier caliper that allows measurement of center distance of two holes with an equal diameter and measurement of distance between edge face and hole center.
● A special-purpose gage block is provided.
● The printer output function is provided.

 

Contact : 

There are a variety of ways to get in touch with the Precision Measurement Professionals at Semiki Corp.
 Please use the contact information on this page : www.semiki.com to get in touch with us.

Semiki instrumentation Co., Ltd
Email:  sales@semiki.com
address : 63 Ho Ba Kien St., 15 Ward, Dist.10, HCMC, VN

 

~DOING OUR BEST FOR YOU~