máy kiểm tra độ dẫn điện FISCHER SIGMASCOPE SMP350

 

 

Helmut Fischer compact handheld device for determining the electrical conductivity of non-ferrous metals such as aluminum or copper.

 

model: SIGMASCOPE SMP350

 

SIGMASCOPE SMP350 is a compact handheld device for determining the electrical conductivity of non-ferrous metals such as aluminum or copper.

The measured conductivity further enables you to draw conclusions about the hardness and strength of heat-treated materials.

Evidence of heat damage and material fatigue can thus be established.

For this, the phase-sensitive eddy current method is used, which is approved for the measurement of conductivity according to DIN EN 2004-1 and ASTM E 1004.

 

 

Applications:

- Conductivity testing on raw materials for sorting and quality assurance
- Inspection of alloying in coinage (e.g. the conductivity of Euro coins)
- Assessment of the hardness and strength of heat-treated materials
- Control of the material stability of airframes or similar components that can be altered by temperature swings
- Estimation of the phosphorous content in copper alloys or copper-bearing materials
- Tracking of precipitation processes, e.g. in Cu-Cr alloys
-Inspection of the homogeneity of alloys
- Scrap sorting

 

 

Technical data :

• Measurements pursuant to ASTM E 1004 and DIN EN 2004-1
• SMP350 with probe FS40 fulfills Boeing specification BAC 5651
• Measurement frequencies ranging from 15 kHz to 2 MHz, depending on the probe
• Measurement range: 0.5 – 65 MS/m or 1 – 112% IACS
• Measurement precision at ambient temperature: ±0.5% of reading
• Operating temperature: 0 – 40 °C
• Lift-off compensation to 500 μm
• Smallest diameter measurement area without noticeable influence on the reading: 13 mm
• Connector for electrical conductivity probe, with or without integrated temperature sensor
• Connector for optional temperature sensor TF100A
• USB communication and printer port
• Power supply via battery or mains electricity

 

Accesories: 

 *  Probe FS40 family

 

 

 

* Calibration standards

 

 

 

Maintenance and calibration : 

 

► We also have calibration certificate attached ( optional )
► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI CORP

 

 

 

 

DISTRIBUTED BY:

 

Semiki instrumentation Co., Ltd
Email:  sales@semiki.com
Office tel: +84 28 2253 3522

 

 

~DOING OUR BEST FOR YOU~