Name: KYOWA CDA-900A, CDA-900A-DC bộ ghi nhận tín hiệu strain gauge (120, 350 Ω)
Brand: KYOWA
SKU: CDA-900A
Availability: PreOrder

KYOWA ELECTRONIC INSTRUMENTS

Signal Conditioner

CDA/CDV-900A

The CDV-900A, CDA-900A is a Signal Conditioner which features wide frequency response range from DC to 500 kHz, and excellent nonlinearity within ±0.01%FS. Simple setting enables improvement of work efficiency greatly.

Model:

CDA-900A/ CDA-900A-DC

CDV-900A/ CDV-900A-DC

· High sensitivity (Up to 10000 times) · Fast response (DC to 500 kHz) · Long-distance testing (CDA-900A can measure up to 2 km) · Excellent nonlinearity (Within ±0.01%FS) · Universal power supply (100 to 240 VAC or 10.5 to 15 VDC)

Specification

Standard Accessories Output cable U-08, U-59, AC power cable P-25 (With 2-pin conversion plug CM-52, CDV/ CDA-900A only), DC power cable P-69 (CDV/CDA-900A-DC only), Ferrite core × 5 (CDV/CDA-900A-DC only), Instruction manual Optional Accessories Input cable U-37, Extension cables N-81 to N-85, Housing case YC-A, Amplifier stand FA-1B, AC adapter SA-10A-AMP (CDV/CDA-900A-DC only)

Features

Easy setting: Just set input strain and output voltage at the time. Light weight: Approximately 30% lighter than the conventional signal conditioner. Monitor and bar graph meter are standard provision. Not only static strain but also dynamic strain signal can be monitored. Low noise: Reduce noise by 30% than the conventional product. DC amplifier function provided: Capable of 10,000 amplifications as a DC amplifier TEDS*1 function: When using strain gage transducer with built-in TEDS circuit, the internal gain can be easily set without referring the Test Data Sheet by pressing the TEDS switch. TEDS-compatible sensors and remote-sensing sensors. Capable of using both TEDS-compatible sensors and remote-sensing sensors by using the TEDS- sensor/remote--sensing sensor detection function. ACTL LOAD function: The internal gain can be set with the actual load or external calibrator by pressing the ACTL LOAD switch. Bridge resistance check function: This function checks breaking of wires in the strain gage bridge, and the monitor indicates which wires are broken. Confirming the CE marking: The CDV/CDA-900A-DC conforms to the EMC Directive (applicable standard: EN61326-1).

SYSTEM CONFIGURATION

This section describes a general system configuration when using the CDV/CDA-900A-DC for measurement.

Maintenance and calibration : ► We also have calibration certificate attached ( optional ) ► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI Ins