KETT Paper Moisture Tester KH-70 thiết bị đo độ ẩm giấy, hộp carton

Kett Japan

 

Paper Moisture Tester

Model: KH-70

  ● Easy to operate.

When you press the sensor against the paper to be measured, the moisture content is displayed.

● Paper moisture can be measured non-destructively.

Sheets and rolls of paper can also be measured as they are.

● You can select from four types of cardboard, two types of board paper, five types of general paper, and one user calibration curve.

The selection key allows you to call up standard pre-installed calibration curves for cardboard, kraft paper, etc.

● Average moisture content can be measured up to a depth of 50 mm.

For more accurate moisture measurement , the average moisture content is measured not only on the surface but also up to a depth of 50 mm. The paper to be measured should be stacked to a thickness of 50 mm or more. Stack the samples to a depth of at least 50 mm, and ensure that there is as little air as possible between the samples. If the samples cannot be stacked more than 50 mm thick, place them on a polystyrene foam underlay. However, even in this case, the sample must be at least 20mm thick, and the total thickness of the sample and the underlay must be at least 50mm.

Kett KH-70 Paper Moisture Tester

• High Frequency dielectric constant
• Range 0 to 30% (Paper), 0 to 175% (Cardboard)
• Resolution 0.1%
• Accuracy ± 2%
• LCD Display
• Function Alarm
• Battery Alkaline 9V x 1
• Dimension 150 x 72 x 85mm (150g)

Approx. 40° Angle to material	Paper	Cardboard
	P1 Filter paper, Tissue paper P2 Semi-chemical pulp, crepe paper, Test liner P3 Packaging paper, Fluting paper, 80 g/sqm P4 Kraft paper P5 Offset paper P6 Customer-specified calibration curves	C1      3.6mm 2 Sheets  C2      6.5mm 3 Sheets C3      2.8mm 3 Sheets C4      1.5mm 6 Sheets C5      1.0mm 3 Sheets C5      2.0mm 6 Sheets

  Pic.:Paper Moisture Tester KETT KH-70 ( 0-33%) at Semiki's warehouse  

Specifications